oak:tutorials:pinout
This is an old revision of the document!
Table of Contents
Oak Pinout Diagram
General Notes:
Pin 10 is not PWM capable. Pins 0-9 are, and they also have internal pullups.
Pin 0, 1, and 2 must not be held low at boot. Be careful not to attach pull down resistors to them (pull-ups are fine) unless they are only active after power up.
Pin 6 must not be held high at boot. Be careful not to attach pull up resistors to it (pull-downs are fine) unless they are only active after power up.
There is only one analog input capable pin, A0.
i2C
SDA = 0
SCL = 2
UART / Serial
RX = 3
TX = 4
SPI
SS = 6
MOSI = 7
MISO = 8
SCK = 9
Other
BUILTIN_LED = 1
A0 = 11
Oak Pin to ESP8266 GPIO Mapping
| Oak Pin | P0 | P1 | P2 | P3 | P4 | P5 | P6 | P7 | P8 | P9 | P10 | P11 |
|---|---|---|---|---|---|---|---|---|---|---|---|---|
| GPIO | 2 | 5 | 0 | 3 | 1 | 4 | 15 | 13 | 12 | 14 | 16 | 17 |
oak/tutorials/pinout.1459646202.txt.gz · Last modified: 2016/04/02 18:16 by pfeerick
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
