oak:tutorials:pinout
This is an old revision of the document!
Oak Pinout Diagram
Notes:
Pin 10 is not PWM capable. 0-9 are.
Pin 0 and 2 must not be held low at boot. Be careful not to attach pull down resistors to them (pull-ups are fine) unless they are only active after power up.
Pin 1 and 6 must not be held high at boot. Be careful not to attach pull up resistors to it (pull-downs are fine) unless they are only active after power up.
oak/tutorials/pinout.1458608631.txt.gz · Last modified: 2016/03/21 18:03 by digistump
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
