Differences

This shows you the differences between two versions of the page.

--- holiday:assembly [2016/12/23 14:20]
digistump [Step 6 - TREE KIT ONLY]
+++ holiday:assembly [2016/12/27 14:15]
digistump [Step 7 (optional)]
@@ Line 97: / Line 97: @@
 Insert the speaker in the locations indicated on the bottom (side with "Holidays 2016" printed on it) of the board (as shown), solder leads on top side. Match the side shown in the image below as the "+" side with the side of the speaker with a "+" (on the sticker on the speaker).
-{{ :holiday:speakerplus.jpg?direct&300 |}}
+{{ :holiday:speakerplus.jpg?direct&500 |}}
 After soldering remove the sticker for full volume.
@@ Line 111: / Line 111: @@
 Insert the battery holder  on the bottom (side with "Holidays 2016" printed on it) into the two holes as shown on the photos, solder leads on top side.
+**IMPORTANT NOTE**: Please ensure the wires on the bottom of the battery holder do not make contact with the LED pins or anything else under the battery holder, if they do we suggest using some tape (electrical or masking) to protect them from shorting out.
 **Tree**

Digistump Wiki