Can't upload code to Oak (device no longe available on this account)

[pdominique]

Hi,

I just followed the instructions (http://digistump.com/wiki/oak/tutorials/arduino) but I'm stuck at the last step (first upload). I get the following error message in the Arduino IDE when I hit the upload button:

Error : Selected device is no longer available on this account, please run this tool from the command line to select a device.

I can see the device in the Particle Dashboard and it's connected to the cloud. I'm using the Arduino IDE version 1.6.8 because I'm behind a proxy and as far as I know 1.6.5 doesn't have any proxy settings. Is the Oak CLI supposed to work behind a proxy?

@digistump: FYI the Oak is a pain to use in a corporate environment. Doesn't support WPA2-Enterprise, can't connect to a wireless network when there are multiple networks with the same SSID, doesn't seem to support proxy servers... We just bought 65 Oaks but I'm afraid no one will be able to use them at the office. :-(

[PeterF]

Have you run the Oak CLI tool to select which Oak to upload to? If you haven't, have a another look at that tutorial, it's the last step before the 'your first upload' heading, about 2/3 of the way down the page. I'll leave it up to Erik or someone else who knows to respond to the proxy question, as I suspect it will be an issue, but I don't really know

[pdominique]

Have you run the Oak CLI tool to select which Oak to upload to? If you haven't, have a another look at that tutorial, it's the last step before the 'your first upload' heading, about 2/3 of the way down the page. I'll leave it up to Erik or someone else who knows to respond to the proxy question, as I suspect it will be an issue, but I don't really know

Yes I did. Well, as I suspected this seems to be a proxy issue because it works just fine when I'm home.