safe_mode
Differences
This shows you the differences between two versions of the page.
|
safe_mode [2016/11/19 19:05] shiny created |
safe_mode [2016/11/19 19:23] (current) shiny |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| Safe mode puts your Oak into a state where you can access it again just like you did when doing the initial setup, and also stops any buggy code from locking it up again. | Safe mode puts your Oak into a state where you can access it again just like you did when doing the initial setup, and also stops any buggy code from locking it up again. | ||
| + | |||
| + | To access safe mode: | ||
| + | |||
| + | - Disconnect the power from the oak | ||
| + | - Put a jumper/link/wire between P1 and GND | ||
| + | - Power up the Oak | ||
| + | - After 2-3 seconds, remove the jumper link between P1 and GND | ||
| + | - The Oak should now be doing a triple blink pattern like the one above, indicating it is now in safe mode. | ||
| + | |||
safe_mode.1479611150.txt.gz · Last modified: 2016/11/19 19:05 by shiny
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
