User Tools

Site Tools


safe_mode

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

safe_mode [2016/11/19 19:05]
shiny created
safe_mode [2016/11/19 19:23]
shiny
Line 1: Line 1:
 Safe mode puts your Oak into a state where you can access it again just like you did when doing the initial setup, and also stops any buggy code from locking it up again. ​ Safe mode puts your Oak into a state where you can access it again just like you did when doing the initial setup, and also stops any buggy code from locking it up again. ​
 +
 + To access safe mode:
 +
 +  -     ​Disconnect the power from the oak
 +  -     Put a jumper/​link/​wire between P1 and GND
 +  -     Power up the Oak
 +  -     After 2-3 seconds, remove the jumper link between P1 and GND
 +  -     The Oak should now be doing a triple blink pattern like the one above, indicating it is now in safe mode.
 +
safe_mode.txt · Last modified: 2016/11/19 19:23 by shiny