oak:tutorials:wificonfig
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
oak:tutorials:wificonfig [2016/03/19 02:32] digistump |
oak:tutorials:wificonfig [2016/04/07 15:31] (current) mikekgr |
||
|---|---|---|---|
| Line 11: | Line 11: | ||
| - If your current WiFi settings are failing the Oak will enter automatically. | - If your current WiFi settings are failing the Oak will enter automatically. | ||
| - If you connect Pin 1 to GND and then power on the Oak, and disconnect after about 3 seconds so you can see the LED blink since it shares the same pin. | - If you connect Pin 1 to GND and then power on the Oak, and disconnect after about 3 seconds so you can see the LED blink since it shares the same pin. | ||
| - | - If you call rebootToConfig(); from a sketch (this allows you to have a button or similar to change wifi settings). | + | - If you call Oak.rebootToConfig(); from a sketch (this allows you to have a button or similar to change wifi settings). |
| With your Oak powered up and in config mode you can proceed with the next section. | With your Oak powered up and in config mode you can proceed with the next section. | ||
oak/tutorials/wificonfig.1458379943.txt.gz · Last modified: 2016/03/19 02:32 by digistump
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
