oak:tutorials:stepper_motor
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revision Both sides next revision | ||
|
oak:tutorials:stepper_motor [2017/01/14 16:45] Rover#18 |
oak:tutorials:stepper_motor [2017/01/14 16:47] Rover#18 |
||
|---|---|---|---|
| Line 3: | Line 3: | ||
| ** With the Help of an A4988 Stepper Motor Driver ** | ** With the Help of an A4988 Stepper Motor Driver ** | ||
| - | {{:oak:tutorials:oak_stepper_motor_setup.jpg?direct&500 | Oak commanding stepper motor via A4988 driver. A 6-wire 2-phase unipolar stepper motor is shown here, with its coil center tap leads (white/yellow) unconnected. The A4988 driver (red) is upside-down in this photo, showing the backside of the board, which is opposite of the view shown in the Fritzing diagram. The motor is powered from a common 12V DC wall wart transformer, with a 68uF cap connected at the jack. }} | + | {{ :oak:tutorials:oak_stepper_motor_setup.jpg?direct&500 | Oak commanding stepper motor via A4988 driver. A 6-wire 2-phase unipolar stepper motor is shown here, with its coil center tap leads (white/yellow) unconnected. The A4988 driver (red) is upside-down in this photo, showing the backside of the board, which is opposite of the view shown in the Fritzing diagram. The motor is powered from a common 12V DC wall wart transformer, with a 68uF cap connected at the jack. }} |
| **This lesson teaches you how to:** | **This lesson teaches you how to:** | ||
oak/tutorials/stepper_motor.txt · Last modified: 2017/01/14 16:52 by Rover#18
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
