oak:tutorials:serial
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
oak:tutorials:serial [2016/02/26 03:18] spiderbike [Connecting to the Serial output of the Oak] |
oak:tutorials:serial [2016/03/02 03:02] (current) spiderbike [Connecting] |
||
|---|---|---|---|
| Line 37: | Line 37: | ||
| * enter **1** for Receive polarity (Idle 1 *default) | * enter **1** for Receive polarity (Idle 1 *default) | ||
| * enter **2** for select output type (Normal (H=3.3V, L=GND)) | * enter **2** for select output type (Normal (H=3.3V, L=GND)) | ||
| - | * Now you need to change the baud rate of the Bus pirate to match, as you are just going to pass thru data as it wont keep otherwise | + | * Now you need to change the baud rate of the Bus pirate to match, as you are just going to pass thru data as it wont keep up otherwise |
| * enter **b** to set baud rate | * enter **b** to set baud rate | ||
| * enter **10** for BRG Raw value we want one not specified in the list (74880) which equates to **52** | * enter **10** for BRG Raw value we want one not specified in the list (74880) which equates to **52** | ||
oak/tutorials/serial.1456485502.txt.gz · Last modified: 2016/02/26 03:18 by spiderbike
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
