oak:tutorials:serial
This is an old revision of the document!
Table of Contents
Connecting to the Serial output of the Oak
The first step is to connect the cables from your Bus Pirate or any standard UART cable to the Oak
in the photo example of the Bus Pirate the wires I have used are as follows
Bus Pirate
- Grey – Ground
- Blue – MOSI
- Purple – MISO
Oak
- Grey – GND
- Blue – RX
- Purple – TX
oak/tutorials/serial.1456483884.txt.gz · Last modified: 2016/02/26 02:51 by spiderbike
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
