Digistump Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== Connecting to the Serial output of the Oak ======

The first step is to connect the cables from your Bus Pirate or any standard UART cable to the Oak

in the photo example of the Bus Pirate the wires I have used are as follows



===== Bus Pirate =====
  * Grey -- Ground
  * Blue -- MOSI
  * Purple -- MISO

{{:oak:tutorials:bus_pirate.jpg?200|}}

===== Oak =====
  * Grey -- GND
  * Blue -- RX
  * Purple -- TX

{{:oak:tutorials:oakpinvsship.png?200|}}



===== Connecting =====

  * Open terminal. I use [[http://www.chiark.greenend.org.uk/~sgtatham/putty/download.html|Putty]]
  * Set Connection type to Serial
  * Click on the Serial options link bottom left of Putty and set to the COM port your Bus Pirate is on (You can find out this info in Device manager in windows under the Ports Com & Lpt section)
  * set the baud rate to 115200, Data bits 8, stop bits 1, parity none, Flow control none and hit open
  * entering **i** will give you some basic info
  * enter **m** to change mode
  * enter **3** for Uart
  * enter **10** for BRG Raw value we want one not specified in the list (74880) which equates to **52**
  * enter **1** for Data bits and parity (8, NONE *default)
  * enter **1** for Stop bits (1 *default)
  * enter **1** for Receive polarity (Idle 1 *default)
  * enter **2** for select output type (Normal (H=3.3V, L=GND))
  * Now you need to change the baud rate of the Bus pirate to match, as you are just going to pass thru data as it wont keep otherwise
  * enter **b** to set baud rate
  * enter **10** for BRG Raw value we want one not specified in the list (74880) which equates to **52**
  * after you enter **52** it will ask you to adjust terminal to match, so Right click on the top of the putty window and click change settings
  * Change Speed (Baud) rate to **74880** in the the Connection/Serial section and press apply
  * enter **(1)** to change the Bus Pirate in to UART Bridge mode and press **y** to confirm
  * now power cycle your oak and should get something in the terminal like this

//ets Jan  8 2013,rst cause:2, boot mode:(3,0)

load 0x40100000, len 3632, room 16
tail 0
chksum 0xc0
load 0x3ffe8000, len 352, room 8
tail 8
chksum 0x82
csum 0x82

OakBoot v1 - N,BC,8
//
Digistump Wiki

User Tools

Site Tools

Page Tools
