oak:tutorials:serial
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revision Both sides next revision | ||
|
oak:tutorials:serial [2016/02/26 03:15] spiderbike [Oak] |
oak:tutorials:serial [2016/02/26 03:18] spiderbike [Connecting to the Serial output of the Oak] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Connecting to the Serial output of the Oak ====== | ====== Connecting to the Serial output of the Oak ====== | ||
| - | The first step is to connect the cables from your Bus Pirate or any standard UART cable to the Oak | + | The first step is to connect the cables from your Bus Pirate or any standard UART cable to the Oak, I had a bus Pirate handy so I used this, which adds some extra steps, but others may find the general info useful |
| in the photo example of the Bus Pirate the wires I have used are as follows | in the photo example of the Bus Pirate the wires I have used are as follows | ||
oak/tutorials/serial.txt · Last modified: 2016/03/02 03:02 by spiderbike
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
