oak:tutorials:rgb-led
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revision Both sides next revision | ||
|
oak:tutorials:rgb-led [2016/03/23 23:16] jwhendy [Components used] |
oak:tutorials:rgb-led [2016/03/23 23:17] jwhendy [Components used] |
||
|---|---|---|---|
| Line 12: | Line 12: | ||
| |Jumper wires | 4 | | | |Jumper wires | 4 | | | ||
| |RGB LED| 1 | whitish LED with 4 leads, one longer than the others | | |RGB LED| 1 | whitish LED with 4 leads, one longer than the others | | ||
| - | |220 ohm resistor| 3 | | | + | |Resistor, 220 ohm| 3 | Red-Red-Brown| |
| **Note:** 220 ohms is a ballpark recommendation; acceptable values are between 100 - 1k ohms. | **Note:** 220 ohms is a ballpark recommendation; acceptable values are between 100 - 1k ohms. | ||
oak/tutorials/rgb-led.txt · Last modified: 2016/04/19 17:44 by jwhendy
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
