User Tools

Site Tools


oak:tutorials:proto

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision Both sides next revision
oak:tutorials:proto [2016/01/17 16:48]
briankb created
oak:tutorials:proto [2016/01/17 18:24]
briankb
Line 31: Line 31:
 [IMAGE SHIELD + MALE HEADERS with Ruler] [IMAGE SHIELD + MALE HEADERS with Ruler]
  
-Cut a length of male headers ​pins long and one 3 pins long. Insert into corresponding positions (on the bottom of the board) and solder each pin.+Cut or Snap a length of two male headers ​pins long and one 3 pins long. Insert into corresponding positions (on the bottom of the board) and solder each pin
 + 
 +**Tip:** Inserting the headers into a breadboard and then placing the board on top can make this process easier. Be caureful not to heat the headerpins to the point that it melts the plastic surrounding the pin or the breadboard. 
 + 
 +**Tip 2:** If not using the above tip, solder one pin then check that the header is in the right position and is square to the PCB before continuing the rest.
  
 [ASSEMBLED CLOSEUP] [ASSEMBLED CLOSEUP]
  
-**Tip:** Inseting the headers into a breadboard and then placing the board on top can make this process easier.+
  
 **Note:** If you are using stackable headers, use them here instead of the standard male headers. **Note:** If you are using stackable headers, use them here instead of the standard male headers.
oak/tutorials/proto.txt · Last modified: 2016/02/19 17:50 by digistump