oak:tutorials:levelshift
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revision Both sides next revision | ||
|
oak:tutorials:levelshift [2016/03/15 19:39] exeng [Using the Oak Level Shifter:] |
oak:tutorials:levelshift [2016/03/15 22:26] exeng [Using the Oak Level Shifter:] |
||
|---|---|---|---|
| Line 144: | Line 144: | ||
| //**Pinout Correction for the P1 Servo Header:**// | //**Pinout Correction for the P1 Servo Header:**// | ||
| - | The pins labeled GND and P1 for the center servo header on the level shifter are reserved. GND is actually P1 and P1 is actually GND. This only applies to the servo header that uses P1 for signal output. | + | The pins labeled GND and P1 for the center servo header on the level shifter are reversed. GND is actually P1 and P1 is actually GND. This only applies to the servo header that uses P1 for signal output. |
| [TODO: Add photo indicating the corrected pin layout for this servo header] | [TODO: Add photo indicating the corrected pin layout for this servo header] | ||
| [[oak-level-shifter-shield-24.jpg|{{oak-level-shifter-shield-24.jpg}}]] | [[oak-level-shifter-shield-24.jpg|{{oak-level-shifter-shield-24.jpg}}]] | ||
oak/tutorials/levelshift.txt · Last modified: 2016/03/21 16:17 by digistump
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
