oak:tutorials:kit_parts
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
oak:tutorials:kit_parts [2016/03/19 03:01] digistump created |
oak:tutorials:kit_parts [2016/03/19 03:01] digistump |
||
|---|---|---|---|
| Line 3: | Line 3: | ||
| Starter Kit Parts List: | Starter Kit Parts List: | ||
| - | 3x Oaks | + | * 3x Oaks |
| - | 1x Clear Plastic Part Box | + | * 1x Clear Plastic Part Box |
| - | 1x 400 hole 85x55mm Breadboard | + | * 1x 400 hole 85x55mm Breadboard |
| - | 1x 3ft Micro USB Cable | + | * 1x 3ft Micro USB Cable |
| - | 1x Set of 40 M to M 30cm Jumper Wires | + | * 1x Set of 40 M to M 30cm Jumper Wires |
| - | 1x Set of 40 M to F 30cm Jumper Wires | + | * 1x Set of 40 M to F 30cm Jumper Wires |
| - | 1x 9g Micro Servo | + | * 1x 9g Micro Servo |
| - | 1x GL5528 Photocell | + | * 1x GL5528 Photocell |
| - | 1x HC-SR04 Ultrasonic Range Module | + | * 1x HC-SR04 Ultrasonic Range Module |
| - | 3x 2N2222 Transistors TO-92 | + | * 3x 2N2222 Transistors TO-92 |
| - | 2x 1N4148 Diodes | + | * 2x 1N4148 Diodes |
| - | 1x TTP223B Touch Module | + | * 1x TTP223B Touch Module |
| - | 1x DS18B20 One Wire Temperature Sensor TO-92 | + | * 1x DS18B20 One Wire Temperature Sensor TO-92 |
| - | 1x 5mm RGB LED Common Cathode | + | * 1x 5mm RGB LED Common Cathode |
| - | 3x 3mm Red LED | + | * 3x 3mm Red LED |
| - | 3x 3mm Green LED | + | * 3x 3mm Green LED |
| - | 3x 3mm Yellow LED | + | * 3x 3mm Yellow LED |
| - | 3x 12mm Tactile Button (see image) | + | * 3x 12mm Tactile Button (see image) |
| - | 1x 3.3v Active Buzzer | + | * 1x 3.3v Active Buzzer |
| - | 10x 150 Ohm ¼W Resistors | + | * 10x 150 Ohm ¼W Resistors |
| - | 10x 10K Ohm ¼W Resistors | + | * 10x 10K Ohm ¼W Resistors |
| - | 10x 4.7K Ohm ¼W Resistors | + | * 10x 4.7K Ohm ¼W Resistors |
| - | 1x HS0038 IR Receiver | + | * 1x HS0038 IR Receiver |
| - | 1x QRD1114 IR Interrupter | + | * 1x QRD1114 IR Interrupter |
| - | 1x SW-520D Rolling Ball Switch | + | * 1x SW-520D Rolling Ball Switch |
| The Ultimate Kit includes all of the above, plus: | The Ultimate Kit includes all of the above, plus: | ||
| - | 2x Additional Oaks | + | * 2x Additional Oaks |
| - | 1x Digispark/Oak Button Shield | + | * 1x Digispark/Oak Button Shield |
| - | 1x Oak TFT LCD Shield | + | * 1x Oak TFT LCD Shield |
| - | 1x DigiLED Shield | + | * 1x DigiLED Shield |
| - | 1x HC-SR501 PIR Module | + | * 1x HC-SR501 PIR Module |
| - | 1x Breadboard Power Supply Module | + | * 1x Breadboard Power Supply Module |
| - | 1x MC-38 Magnetic Door Switch | + | * 1x MC-38 Magnetic Door Switch |
| - | 1x Soil Moisture Sensor Module Set | + | * 1x Soil Moisture Sensor Module Set |
| - | 1x 9V Battery | + | * 1x 9V Battery |
| - | 1x 9V to Barrel Jack Cable | + | * 1x 9V to Barrel Jack Cable |
oak/tutorials/kit_parts.txt · Last modified: 2016/03/19 03:01 by digistump
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
