User Tools

Site Tools


oak:tutorials:button

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
oak:tutorials:button [2016/03/20 05:12]
djflix
oak:tutorials:button [2016/03/20 05:13] (current)
djflix
Line 62: Line 62:
  
 **2. LED** **2. LED**
-After adding the resistors, you can add the LED. When connecting the LED, double-check the polarity. The shorter leg is the cathode (-) and the longer leg is the anode (+). Connect the **cathode** to the top (10K) resistor, and connect the **anode** to P2 of the Oak using a wire (the blue wire in the example).+After adding the resistors, you can add the LED. When connecting the LED, double-check the polarity. The shorter leg is the cathode (-) and the longer leg is the anode (+). Connect the **cathode** to the top (150 Ohm) resistor, and connect the **anode** to P2 of the Oak using a wire (the blue wire in the example).
  
 **3. Button** **3. Button**
oak/tutorials/button.txt · Last modified: 2016/03/20 05:13 by djflix