PAGE UNDER CONSTRUCTION

This page is being put together due to this discussion: https://digistump.com/board/index.php/topic,2132.0.html

In a nutshell, you can use an Oak offline if you serial program it. No wifi or internet is needed for that mode of programming. However, you may not be using an Oak if that was the case. So perhaps your internet or wifi is intermittent, or you want to be able to turn the wifi off the save power. Can you do it? YES!

Basically, run the Oak in manual safe mode only mode so it doesn't auto-reboot when there is no wifi, and run the oak in SYSTEM_MODE(SEMI_AUTOMATIC) or SYSTEM_MODE(MANUAL)? to manage the wifi connection / internet connection yourself in code. You can then have the Oak connect to wifi when it's available, or in response to a button, etc.

If you want to manage your wifi manually, rather than via the SoftAP / OakConfig page, you can do that too. You have to option of using DHCP IP addresses, or static IP addresses also. If you don't know what a Static or DHCP IP address is, stuck with DHCP. The following two examples don't have a Particle connection until you enable them, nor do they connect to your WiFi until you tell them to.

SYSTEM_MODE(MANUAL);

#include <ESP8266WiFi.h>

//Static IP stuff
char SSID[] = "yournetwork";    // your network SSID
char passwd[] = "yourpassword"; // your network password

void setup()
{
  pinMode(LED_BUILTIN, OUTPUT);
  
  //don't save these details
  WiFi.persistent(false);

  //start the WiFi connection process
  WiFi.begin_internal(SSID, passwd, 0, NULL);

  //wait for WiFi to connect
  while (WiFi.status() != WL_CONNECTED)
  {
    digitalWrite(LED_BUILTIN, HIGH);
    delay(100);
    digitalWrite(LED_BUILTIN, LOW);
    delay(100);
  }
}

void loop() 
{
  digitalWrite(LED_BUILTIN, HIGH);   // turn the LED on (HIGH is the voltage level)
  delay(1000);                       // wait for a second
  digitalWrite(LED_BUILTIN, LOW);    // turn the LED off by making the voltage LOW
  delay(1000);                       // wait for a second  
}

SYSTEM_MODE(MANUAL);

#include <ESP8266WiFi.h>

//Static IP stuff
char SSID[] = "yournetwork";    // your network SSID
char passwd[] = "yourpassword"; // your network password

//WiFi config stuff
IPAddress ip(192, 168, 0, 70); //your static IP
IPAddress gateway(192, 168, 0, 1); //your gateway IP
IPAddress subnet(255, 255, 255, 0);  //your subnet mask

void setup()
{
  pinMode(LED_BUILTIN, OUTPUT);
  
  //don't save these details
  WiFi.persistent(false);

  //configure the WiFi to use the custom settings
  WiFi.config(ip, gateway, subnet);

  //start the WiFi connection process
  WiFi.begin_internal(SSID, passwd, 0, NULL);

  //wait for WiFi to connect
  while (WiFi.status() != WL_CONNECTED)
  {
    digitalWrite(LED_BUILTIN, HIGH);
    delay(100);
    digitalWrite(LED_BUILTIN, LOW);
    delay(100);
  }
}

void loop() 
{
  digitalWrite(LED_BUILTIN, HIGH);   // turn the LED on (HIGH is the voltage level)
  delay(1000);                       // wait for a second
  digitalWrite(LED_BUILTIN, LOW);    // turn the LED off by making the voltage LOW
  delay(1000);                       // wait for a second  
}

MMTC