digix:tutorials:mesh
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
digix:tutorials:mesh [2013/09/06 17:35] digistump |
digix:tutorials:mesh [2013/09/16 18:08] (current) digistump |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | **Note:** The nRF24L01+ modules is installed in a low profile socket but has normal height pins, to make it sit firmly and lower in its socket remove about 1/3 from each pin with a pair of wire cutters/angle clippers. | ||
| + | |||
| Examples can be found once you install the DigiX add ons at: Examples->RF24-> | Examples can be found once you install the DigiX add ons at: Examples->RF24-> | ||
digix/tutorials/mesh.1378514149.txt.gz · Last modified: 2013/09/06 17:35 by digistump
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
