digix:tutorials:mesh
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
digix:tutorials:mesh [2013/09/06 16:22] digistump created |
digix:tutorials:mesh [2013/09/16 18:08] (current) digistump |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | **Note:** The nRF24L01+ modules is installed in a low profile socket but has normal height pins, to make it sit firmly and lower in its socket remove about 1/3 from each pin with a pair of wire cutters/angle clippers. | ||
| + | |||
| + | Examples can be found once you install the DigiX add ons at: Examples->RF24-> | ||
| + | |||
| A great introduction to these modules: http://arduino-info.wikispaces.com/Nrf24L01-2.4GHz-HowTo | A great introduction to these modules: http://arduino-info.wikispaces.com/Nrf24L01-2.4GHz-HowTo | ||
digix/tutorials/mesh.1378509729.txt.gz · Last modified: 2013/09/06 16:22 by digistump
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
