Digistump Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

**Note:** The nRF24L01+ modules is installed in a low profile socket but has normal height pins, to make it sit firmly and lower in its socket remove about 1/3 from each pin with a pair of wire cutters/angle clippers.

Examples can be found once you install the DigiX add ons at: Examples->RF24->

A great introduction to these modules: http://arduino-info.wikispaces.com/Nrf24L01-2.4GHz-HowTo

Recommended library (included in the DigiX addon files): https://github.com/maniacbug/RF24 Tutorial on that library: http://arduino-info.wikispaces.com/nRF24L01-RF24-Examples

CSN uses pin 52 - CE is on Pin 53

Pin 51 can be connected to IRQ via the solder jumper on the bottom of the board.

The add-on files include the RF24 library and examples modified to work with the DigiX

If you use your own copy of the RF24 library the following line:
RF24 radio(9,10);
Should be changed to:
RF24 radio(53,52);

A mesh network layer for the same library can be found here: https://github.com/maniacbug/RF24Network
(Tutorials on this need to be added!)

Digistump Wiki

User Tools

Site Tools

Page Tools