The DigiX has a 32-bit 84 MHz MCU, embedded low power Wi-Fi (b/g/n) and mesh networking, 99 usable i/o pins, audio output, USB on the go support, onboard EEPROM, onboead microSD slot, built in real time clock, and is 100% compatible with anything that works with the Arduino Due - no adapters, code changes, or special software needed! This is the ultimate Arduino compatible development board, ready for any project!

Here are the specifications:

• 84 MHz Clock Speed
• 32-bit ARM Processor (AT91SAM3X8E)
• On board 802.11b/g/n WiFi Module (FCC/CE Approved)
• On board nRF24L01+ wireless module (removable)
• 3.3V, 3.4-5.5V (LiPo Ready), 5V, or 6-16V input (onboard buck regulator)
• 96KB SRAM
• 512KB Flash
• 1A @ 3.3V and 1A @ 5V Available (when powered at 5V+)
• 99 I/O Pins
• 12 PWM
• 12 Analog Input
• 2 Analog Output (DAC)
• Onboard LED (connected to Pin 13)
• 130ma Total Current Output from Processor

The DigiX - like the Arduino Due, UDOO, and Spark Core runs at 3.3V. The maximum voltage that the I/O pins can tolerate is 3.3V. Connecting the I/O pins to higher voltages, including 5V, could damage the DigiX.