digispark:tutorials:temp
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
digispark:tutorials:temp [2016/03/22 22:09] exeng [Non-Sleep Mode configuration (or how to prevent Sleep Mode after RESET)] |
digispark:tutorials:temp [2016/06/09 12:03] (current) |
||
|---|---|---|---|
| Line 228: | Line 228: | ||
| - Yellow wire - pin 10 (WAKE) to RESET (RST) | - Yellow wire - pin 10 (WAKE) to RESET (RST) | ||
| - White wire – pin 2 to DS18B20 DQ (note: 4.7K pull-up resister) | - White wire – pin 2 to DS18B20 DQ (note: 4.7K pull-up resister) | ||
| + | - DS18B20 leads from left to right: (1) GND, (2) DQ, (3) Vdd | ||
| {{:digispark:tutorials:oak-temp-sensing-1-wire-bus-2.jpg?direct&200|}} | {{:digispark:tutorials:oak-temp-sensing-1-wire-bus-2.jpg?direct&200|}} | ||
digispark/tutorials/temp.1458709745.txt.gz · Last modified: 2016/03/22 22:09 by exeng
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
