User Tools

Site Tools


digispark:tutorials:robot

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
digispark:tutorials:robot [2016/03/01 18:40]
digistump
digispark:tutorials:robot [2016/06/09 12:03] (current)
Line 56: Line 56:
 Solder the female (non-stackable) headers to your Digispark Pro. Solder the female (non-stackable) headers to your Digispark Pro.
  
-Assemble the Wings Kits - using the male headers from the BLE, BT, WiFi Kit or extra ones - per the instructions here: http://​digistump.com/​wiki/​digispark/​tutorials/​wings+Assemble the Wings Kits - using the male headers from the BLE, BT, WiFi Kit or extra ones - per the instructions here: http://​digistump.com/​wiki/​digispark/​tutorials/​wings ​**NOTE** On the Oak the 5V pin is actually for 3.3V
  
 Assemble the BT, BLE, or WiFi kit (using the correct tutorial for that kit) if applicable - using the included 9 pin stackable headers and the extra 3 pin female header. See the following photos for an example of how it should look with those headers (this is a BT shield, but the BLE and WiFi header setup would be the same): Assemble the BT, BLE, or WiFi kit (using the correct tutorial for that kit) if applicable - using the included 9 pin stackable headers and the extra 3 pin female header. See the following photos for an example of how it should look with those headers (this is a BT shield, but the BLE and WiFi header setup would be the same):
digispark/tutorials/robot.txt · Last modified: 2016/06/09 12:03 (external edit)