digispark:tutorials:robot
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
digispark:tutorials:robot [2016/03/01 18:40] digistump |
digispark:tutorials:robot [2016/06/09 12:03] (current) |
||
|---|---|---|---|
| Line 56: | Line 56: | ||
| Solder the female (non-stackable) headers to your Digispark Pro. | Solder the female (non-stackable) headers to your Digispark Pro. | ||
| - | Assemble the Wings Kits - using the male headers from the BLE, BT, WiFi Kit or extra ones - per the instructions here: http://digistump.com/wiki/digispark/tutorials/wings | + | Assemble the Wings Kits - using the male headers from the BLE, BT, WiFi Kit or extra ones - per the instructions here: http://digistump.com/wiki/digispark/tutorials/wings **NOTE** On the Oak the 5V pin is actually for 3.3V |
| Assemble the BT, BLE, or WiFi kit (using the correct tutorial for that kit) if applicable - using the included 9 pin stackable headers and the extra 3 pin female header. See the following photos for an example of how it should look with those headers (this is a BT shield, but the BLE and WiFi header setup would be the same): | Assemble the BT, BLE, or WiFi kit (using the correct tutorial for that kit) if applicable - using the included 9 pin stackable headers and the extra 3 pin female header. See the following photos for an example of how it should look with those headers (this is a BT shield, but the BLE and WiFi header setup would be the same): | ||
digispark/tutorials/robot.1456886412.txt.gz · Last modified: 2016/03/01 18:40 by digistump
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
