The RGB Shield Kit allows you to build a Digispark shield that connects a Red-Green-Blue tri-colored LED to the Digispark development board. Using the PWM (Pulse Width Modulation) features of the Digispark you can mix the three colors to achieve millions of different shades. Use it as a status indicator, a light show, or even connect it to your computer and change the color remotely.

This is an unassembled kit and requires basic soldering. This is designed for use with the Digispark development board, which is not included.

Image	Part	Quantity	Identification
	RGB Shield PCB	1
	100 (100R) Ohm 1/4W resistor 1% or 5%	2	Brown - Black - Brown
	180 (180R) Ohm 1/4W resistor 1% or 5%	1	Brown - Grey - Brown
	RGB Common Cathode LED	1
	1x40pin male 0.1“ pitch header	9 pins worth

Resistor Values: For more information on how to identify the value of the resistors we recommend these sites: A nice simple resistor calculator: http://www.ealnet.com/m-eal/resistor/resistor.htm A comprehensive article on identification: http://www.diyaudioandvideo.com/Electronics/Color/

Soldering: If you are new to soldering we recommend the following tutorials: Soldering Basics (http://www.sparkfun.com/tutorials/106) and Soldering Crash Course from the folks at Sparkfun (http://www.sparkfun.com/tutorials/354). How to solder from the Curious Inventor: http://store.curiousinventor.com/guides/How_to_Solder

We assume for these assembly instructions that you know the basics of thru-hole soldering. If you don't check out the links above, these boards are very easy to solder - we promise!

Empty kit bag (or if using a raw PCB, aquire parts) and verify contents. Note for Kickstarter Backers and Pre-orders: Headers are not included in each kit bag, but the entire order came with more than enough headers for all kits.

Solder resistors one at a time. Match the value of resistor with the number written within the resistor outline on the board. Solder the leads and clip off the excess. Repeat for all resistors.

When inserting the LED into the board ensure the longest lead of the LED goes through the hole marked ground - this ensure you ahve the LED oriented properly. Solder the LED leads and clip off the excess.

Cut a length of male headers 6 pins long and one 3 pins long. Insert into corresponding positions (on the bottom of the board) and solder each pin.

Tip: Inseting the headers into a breadboard and then placing the board on top can make this process easier.

Note: If you are using stackable headers, use them here instead of the standard male headers.

Your RGB shield is complete!

Note: The programming sections assumes you've installed the Arduino IDE and the Digispark Add-ons: SoftwareSetup

The RGB shield uses the following pins to control the LEDS: Pin 0 → Red Pin 1 → Green Pin 2 → Blue

Turning a color on or off is as simple as this:

void setup() {                
  // initialize the LED pins as outputs
  pinMode(0, OUTPUT);     
  pinMode(1, OUTPUT);     
  pinMode(2, OUTPUT);     
}
 
void loop() {
  digitalWrite(0, HIGH);   	// turn the Red LED On
  delay(1000);              // wait for a second
  digitalWrite(1, HIGH);   	// turn the Green LED On
  delay(1000);              // wait for a second
  digitalWrite(2, HIGH);   	// turn the Blue LED On
  delay(1000);              // wait for a second
  digitalWrite(0, LOW);    	// turn the Red LED off
  digitalWrite(1, LOW);     // turn the Green LED off
  digitalWrite(2, LOW);     // turn the Blue LED off
  delay(1000);              // wait for a second
}

Take a look at the * and * examples for more advanced uses.