Differences

This shows you the differences between two versions of the page.

--- digispark:tutorials:rgb [2015/06/03 00:18]
oscomputing [Assembly:]
+++ digispark:tutorials:rgb [2015/06/03 00:21]
oscomputing [Assembly:]
@@ Line 43: / Line 43: @@
 [[https://s3.amazonaws.com/digispark/images/m/rgb5.jpg|{{https://s3.amazonaws.com/digispark/images/t/rgb5.jpg}}]]
-When inserting the LED into the board ensure the longest lead of the LED goes through the hole marked ground - this ensure you ahve the LED oriented properly. Solder the LED leads and clip off the excess.
+When inserting the LED into the board ensure the longest lead of the LED goes through the hole marked ground - this will ensure you have the LED oriented properly. Solder the LED leads and clip off the excess.
 [[https://s3.amazonaws.com/digispark/images/m/rgb4.jpg|{{https://s3.amazonaws.com/digispark/images/t/rgb4.jpg}}]]
-Cut a length of male headers 6 pins long and one 3 pins long. Insert into corresponding positions (on the bottom of the board) and solder each pin.
+Cut two lengths of male headers, one 6 pins long and another 3 pins long. Insert into corresponding positions (on the bottom of the board) and solder each pin.
 **Tip:** Inserting the headers into a breadboard and then placing the board on top can make this process easier.

Digistump Wiki