digispark:tutorials:rgb
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
digispark:tutorials:rgb [2013/08/17 15:31] bert [Programming:] |
digispark:tutorials:rgb [2015/06/03 00:21] oscomputing [Assembly:] |
||
|---|---|---|---|
| Line 34: | Line 34: | ||
| - | Empty kit bag (or if using a raw PCB, aquire parts) and verify contents. | + | Empty kit bag (or if using a raw PCB, acquire parts) and verify contents. |
| **Note for Kickstarter Backers and Pre-orders:** Headers are not included in each kit bag, but the entire order came with more than enough headers for all kits. | **Note for Kickstarter Backers and Pre-orders:** Headers are not included in each kit bag, but the entire order came with more than enough headers for all kits. | ||
| Line 43: | Line 43: | ||
| [[https://s3.amazonaws.com/digispark/images/m/rgb5.jpg|{{https://s3.amazonaws.com/digispark/images/t/rgb5.jpg}}]] | [[https://s3.amazonaws.com/digispark/images/m/rgb5.jpg|{{https://s3.amazonaws.com/digispark/images/t/rgb5.jpg}}]] | ||
| - | When inserting the LED into the board ensure the longest lead of the LED goes through the hole marked ground - this ensure you ahve the LED oriented properly. Solder the LED leads and clip off the excess. | + | When inserting the LED into the board ensure the longest lead of the LED goes through the hole marked ground - this will ensure you have the LED oriented properly. Solder the LED leads and clip off the excess. |
| [[https://s3.amazonaws.com/digispark/images/m/rgb4.jpg|{{https://s3.amazonaws.com/digispark/images/t/rgb4.jpg}}]] | [[https://s3.amazonaws.com/digispark/images/m/rgb4.jpg|{{https://s3.amazonaws.com/digispark/images/t/rgb4.jpg}}]] | ||
| - | Cut a length of male headers 6 pins long and one 3 pins long. Insert into corresponding positions (on the bottom of the board) and solder each pin. | + | Cut two lengths of male headers, one 6 pins long and another 3 pins long. Insert into corresponding positions (on the bottom of the board) and solder each pin. |
| - | **Tip:** Inseting the headers into a breadboard and then placing the board on top can make this process easier. | + | **Tip:** Inserting the headers into a breadboard and then placing the board on top can make this process easier. |
| **Note:** If you are using stackable headers, use them here instead of the standard male headers. | **Note:** If you are using stackable headers, use them here instead of the standard male headers. | ||
digispark/tutorials/rgb.txt · Last modified: 2016/06/09 12:03 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
