digispark:tutorials:pronrf
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
digispark:tutorials:pronrf [2015/01/12 22:25] digistump |
digispark:tutorials:pronrf [2016/06/09 12:03] (current) |
||
|---|---|---|---|
| Line 32: | Line 32: | ||
| =====Assembly:===== | =====Assembly:===== | ||
| + | |||
| + | **NOTE:** Before you start: If you have a multimeter check for shorts between the GND pin hole and the other pin holes - if you find any please send us an email at support at digistump dot com and we will replace the board. | ||
| Check the contents of your kit and ensure you have all of the parts listed. | Check the contents of your kit and ensure you have all of the parts listed. | ||
| Line 50: | Line 52: | ||
| [[https://s3.amazonaws.com/digispark/images/m/nrf4.JPG|{{https://s3.amazonaws.com/digispark/images/t/nrf4.JPG}}]] | [[https://s3.amazonaws.com/digispark/images/m/nrf4.JPG|{{https://s3.amazonaws.com/digispark/images/t/nrf4.JPG}}]] | ||
| - | Insert the 2x3 female header as shown. Solder the leads on the bottom of the board. | + | Insert the 2x4 female header as shown. Solder the leads on the bottom of the board. |
| [[https://s3.amazonaws.com/digispark/images/m/nrf5.JPG|{{https://s3.amazonaws.com/digispark/images/t/nrf5.JPG}}]] | [[https://s3.amazonaws.com/digispark/images/m/nrf5.JPG|{{https://s3.amazonaws.com/digispark/images/t/nrf5.JPG}}]] | ||
digispark/tutorials/pronrf.1421130335.txt.gz · Last modified: 2015/01/12 22:25 by digistump
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
