digispark:tutorials:pinguide
This is an old revision of the document!
Digispark Pin Usage Guide
This table details the function of each pin on the Digispark and any notes the are relevant.
| Pin Number | Output Voltage | Analogue Port Number analogRead() | PWM | USB | Test LED | I2C | SPI* |
|---|---|---|---|---|---|---|---|
| 0 | 5 V | Y - 504 Hz | Rev 1 | SDA | MISO | ||
| 1 | 5 V | Y - 504 Hz | Rev 2 / 4 | MOSI | |||
| 2 | 5 V | 1 | SCL | SCK | |||
| 3 | 3.6 V | 3 | Y - 1.5k Ohm to 5 V Zener diode (3.6 V maximum in- & output) | ||||
| 4 | 3.6 V | 2 | Y - 1007 Hz | Y Zener diode (3.6 V maximum in- & output) | |||
| 5 | 3 V | 0 |
* Note that the labeling of the pins for SPI is somewhat misleading. The table above is correct, but for use with ISP MISO and MOSI are swapped.
digispark/tutorials/pinguide.1440843542.txt.gz · Last modified: 2015/08/29 03:19 by SukkoPera
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
