digispark:tutorials:oled
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
digispark:tutorials:oled [2014/12/11 14:30] mschorer [Programming:] |
digispark:tutorials:oled [2016/06/09 12:03] (current) |
||
|---|---|---|---|
| Line 5: | Line 5: | ||
| [[https://s3.amazonaws.com/digispark/images/m/oled2.JPG|{{https://s3.amazonaws.com/digispark/images/t/oled2.JPG}}]] | [[https://s3.amazonaws.com/digispark/images/m/oled2.JPG|{{https://s3.amazonaws.com/digispark/images/t/oled2.JPG}}]] | ||
| - | This is an unassembled kit and requires basic soldering. This is designed for use with the Digispark development board, which is not included. | + | This is an unassembled kit and requires basic soldering. This is designed for use with the Digispark development board, which is not included. This kit includes the SSD1306 controlled Monochrome 0.96" 128x64 OLED. |
| =====Parts:===== | =====Parts:===== | ||
| Line 31: | Line 31: | ||
| =====Assembly:===== | =====Assembly:===== | ||
| + | **NOTE:** Before you start: If you have a multimeter check for shorts between the GND pin hole and the other pin holes - if you find any please send us an email at support at digistump dot com and we will replace the board. | ||
| [[https://s3.amazonaws.com/digispark/images/m/oled1.JPG|{{https://s3.amazonaws.com/digispark/images/t/oled1.JPG}}]] | [[https://s3.amazonaws.com/digispark/images/m/oled1.JPG|{{https://s3.amazonaws.com/digispark/images/t/oled1.JPG}}]] | ||
| Line 55: | Line 56: | ||
| =====Programming:===== | =====Programming:===== | ||
| - | **CAN YOU HELP?** There is a mystery line of garbage that doesn't clear on the side of the screen - can you fix the library? | ||
| - | **Fix:** reduce the number of bytes per transfer block in MicroLCDPro.cpp/LCD_SSD1306::clear around line #630 (width >>= 4; make j go to 16 couple of lines further down) | + | Check out the DigisparkOLED library included in the Digistump Arduino IDE 1.5.8C+ |
| - | I've forked the repo and will provide patches soonish ... | + | |
| + | |||
| - | Grab the library at: https://github.com/Defragster/OLEDPRO | ||
| - | Move the MicroLCDpro folder into your arduino libraries folder | ||
digispark/tutorials/oled.1418337052.txt.gz · Last modified: 2014/12/11 14:30 by mschorer
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
