digispark:tutorials:headers
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
digispark:tutorials:headers [2012/12/19 00:32] digistump created |
digispark:tutorials:headers [2014/06/27 13:38] defragster Place KickStarter image in Wiki |
||
|---|---|---|---|
| Line 11: | Line 11: | ||
| Soldering Basics (http://www.sparkfun.com/tutorials/106) and Soldering Crash Course from the folks at Sparkfun (http://www.sparkfun.com/tutorials/354). | Soldering Basics (http://www.sparkfun.com/tutorials/106) and Soldering Crash Course from the folks at Sparkfun (http://www.sparkfun.com/tutorials/354). | ||
| How to solder from the Curious Inventor: http://store.curiousinventor.com/guides/How_to_Solder | How to solder from the Curious Inventor: http://store.curiousinventor.com/guides/How_to_Solder | ||
| + | |||
| + | Adafruit has this excellent guide that starts with the tools needed and then shows detailed pictures, including some of the common problems that beginners experience (http://learn.adafruit.com/adafruit-guide-excellent-soldering) | ||
| **We assume for these assembly instructions that you know the basics of thru-hole soldering. If you don't check out the links above, these boards are very easy to solder - we promise!** | **We assume for these assembly instructions that you know the basics of thru-hole soldering. If you don't check out the links above, these boards are very easy to solder - we promise!** | ||
| Line 23: | Line 25: | ||
| [[https://s3.amazonaws.com/digispark/images/m/digispark3.jpg|{{https://s3.amazonaws.com/digispark/images/t/digispark3.jpg}}]] | [[https://s3.amazonaws.com/digispark/images/m/digispark3.jpg|{{https://s3.amazonaws.com/digispark/images/t/digispark3.jpg}}]] | ||
| + | |||
| + | The Digispark Pro looks like this. | ||
| + | |||
| + | {{:digispark:tutorials:digisparkpro.png?direct&200|}} | ||
| If you'd like to use your Digispark with a breadboard you can cut 6 and 2 pin lengths of male headers (included for Kickstarters and Pre-orders) insert the 6 pin into the corresponding header and the 2 pin into the 5v and GND portion of the 3 pin female header. Flip the Digispark upside down and it should plug into most breadboards with the 5v and GND being connected into the power bus. | If you'd like to use your Digispark with a breadboard you can cut 6 and 2 pin lengths of male headers (included for Kickstarters and Pre-orders) insert the 6 pin into the corresponding header and the 2 pin into the 5v and GND portion of the 3 pin female header. Flip the Digispark upside down and it should plug into most breadboards with the 5v and GND being connected into the power bus. | ||
digispark/tutorials/headers.txt · Last modified: 2016/06/09 12:03 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
