Digistump Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
======Grove Shield Kit Tutorial======

=====Product Description:=====
[[https://s3.amazonaws.com/digispark/images/m/grove2.jpg|{{https://s3.amazonaws.com/digispark/images/t/grove2.jpg}}]][[https://s3.amazonaws.com/digispark/images/m/grove3.jpg|{{https://s3.amazonaws.com/digispark/images/t/grove3.jpg}}]][[https://s3.amazonaws.com/digispark/images/m/grove1.jpg|{{https://s3.amazonaws.com/digispark/images/t/grove1.jpg}}]]

The Grove Shield Kit breaks out four of the six i/o connections on the Digispark development board into two Grove system compatible connectors. One connector is compatible with Grove I2C and Digital modules and the second is compatible with only Digital modules. They also may be compatible with some analog modules. 

This is an unassembled kit and requires basic soldering. This is designed for use with the Digispark development board, which is not included.


=====Parts:=====

^ Image      ^ Part       ^ Quantity          ^Identification^
| Grove Shield PCB|1| |
| 4 Pin Male JST Connector|1| |
| 1x40pin male 0.1" pitch header| 9 pins worth| |

**Soldering:** If you are new to soldering we recommend the following tutorials:
Soldering Basics (http://www.sparkfun.com/tutorials/106) and Soldering Crash Course from the folks at Sparkfun (http://www.sparkfun.com/tutorials/354).
How to solder from the Curious Inventor: http://store.curiousinventor.com/guides/How_to_Solder

**We assume for these assembly instructions that you know the basics of thru-hole soldering. If you don't check out the links above, these boards are very easy to solder - we promise!**


=====Assembly:=====

[[https://s3.amazonaws.com/digispark/images/m/grove2.jpg|{{https://s3.amazonaws.com/digispark/images/t/grove2.jpg}}]]

Insert the two connectors into the top of the board as shown and solder each pin.

[[https://s3.amazonaws.com/digispark/images/m/grove3.jpg|{{https://s3.amazonaws.com/digispark/images/t/grove3.jpg}}]]

Cut a length of male headers 6 pins long and one 3 pins long. Insert into corresponding positions (on the bottom of the board) and solder each pin.

**Tip:** Inserting the headers into a breadboard and then placing the board on top can make this process easier.

**Note:** If you are using stackable headers, use them here instead of the standard male headers.

=====Programming:=====

Please refer to the sample code provided by the sensor or module you will be attaching. 

The pinouts are as follows:

I2C/Digital Connector - P0 and P2

**NOTE:** If you have a "Model B" board you may need to cut the trace to the onboard LED before using any I2C devices - Find out how to tell which board you have and what to do here: [[digispark:tutorials:modelbi2c]]

Digital Connector P1 and P5
Digistump Wiki

User Tools

Site Tools

Page Tools
