digispark:tutorials:digiled
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
digispark:tutorials:digiled [2014/12/28 21:38] kermed Added references to chaining LED's and must-have pins versus nice-to-have |
digispark:tutorials:digiled [2014/12/28 21:38] kermed [Assembly:] |
||
|---|---|---|---|
| Line 60: | Line 60: | ||
| Your DigiLED shield is complete! | Your DigiLED shield is complete! | ||
| - | **Note:** On the back of the shield there is a solder patch to activate pin 5 instead of pin 1 as the digital input. If you are not using the DigiLED as a shield onto the DigiSpark Pro and planning on running it at a distance: You only need to connect the specified digital pin (Pin 1) and bottom 3 pins (5V, GND, VIN). You do not need to connect all 6 pins on the right-hand side of the shield. | + | **Note:** On the back of the shield there is a solder patch to activate pin 5 instead of pin 1 as the digital input. If you are not using the DigiLED as a shield onto the DigiSpark Pro and planning on running it at a distance, you only need to connect the specified digital pin (Pin 1) and bottom 3 pins (5V, GND, VIN). You do not need to connect all 6 pins on the right-hand side of the shield. |
| =====Chaining:===== | =====Chaining:===== | ||
digispark/tutorials/digiled.txt · Last modified: 2016/06/09 12:03 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
