Differences

This shows you the differences between two versions of the page.

--- digispark:tutorials:digiled [2014/12/28 20:31]
kermed Corrected a spelling mistake
+++ digispark:tutorials:digiled [2014/12/28 21:38]
kermed [Assembly:]
@@ Line 60: / Line 60: @@
 Your DigiLED shield is complete!
-**Note:** On the back of the shield there is a solder patch to activate pin 5 instead of pin 1 as the digital input.
+**Note:** On the back of the shield there is a solder patch to activate pin 5 instead of pin 1 as the digital input.  If you are not using the DigiLED as a shield onto the DigiSpark Pro and planning on running it at a distance, you only need to connect the specified digital pin (Pin 1) and bottom 3 pins (5V, GND, VIN).  You do not need to connect all 6 pins on the right-hand side of the shield.
+=====Chaining:=====
+When chaining multiple DigiLED's together, you only need to connect 3 points as a daisy chain using VCC, DO>DI and GND.  For example, LED #1 would need the top 3 pins VCC, DO (out) and GND to connect to DigiLED #2's VCC, DI (in) and GND near the bottom of the board.  If you added LED #3 you would need to connect DigiLED #2's top three pins to the lower-mid pins on DigiLED #3 and so-on and so forth.  After DigiLED 1, the side pins and 5V, GND, VIN should not be connected.
 =====Programming:=====

Digistump Wiki