digispark:tutorials:digiled
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
digispark:tutorials:digiled [2014/12/28 20:15] kermed [Assembly:] |
digispark:tutorials:digiled [2014/12/28 21:40] kermed [Chaining:] |
||
|---|---|---|---|
| Line 54: | Line 54: | ||
| - | When inserting the LED into the board ensure the two longer leasd of the LED goes through the holes marked data out and ground (see photo) - this ensures you have the LED oriented properly. Solder the LED leads and clip off the excess. | + | When inserting the LED into the board ensure the two longer leads of the LED goes through the holes marked data out and ground (see photo) - this ensures you have the LED oriented properly. Solder the LED leads and clip off the excess. |
| [[https://s3.amazonaws.com/digispark/images/m/digiled5.jpg|{{https://s3.amazonaws.com/digispark/images/t/digiled5.jpg}}]] | [[https://s3.amazonaws.com/digispark/images/m/digiled5.jpg|{{https://s3.amazonaws.com/digispark/images/t/digiled5.jpg}}]] | ||
| Line 60: | Line 60: | ||
| Your DigiLED shield is complete! | Your DigiLED shield is complete! | ||
| - | **Note:** On the back of the shield there is a solder patch to activate pin 5 instead of pin 1 as the digital input. | + | **Note:** On the back of the shield there is a solder patch to activate pin 5 instead of pin 1 as the digital input. If you are not using the DigiLED as a shield onto the DigiSpark Pro and planning on running it at a distance, you only need to connect the specified digital pin (Pin 1) and bottom 3 pins (5V, GND, VIN). You do not need to connect all 6 pins on the right-hand side of the shield. |
| + | =====Chaining:===== | ||
| + | When chaining multiple DigiLED's together, you only need to connect 3 points as a daisy chain using VCC, DO>DI and GND. | ||
| + | |||
| + | For example, LED #1 would need the top 3 pins VCC, DO (out) and GND to connect to DigiLED #2's VCC, DI (in) and GND on the second row from the bottom of the board. | ||
| + | |||
| + | If you added LED #3 you would need to connect DigiLED #2's top three pins to the second row from the bottom on DigiLED #3 and so-on and so forth. After DigiLED 1, the side pins and 5V, GND, VIN should not be connected, only the three input and output points for chaining. | ||
| =====Programming:===== | =====Programming:===== | ||
digispark/tutorials/digiled.txt · Last modified: 2016/06/09 12:03 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
