digispark:tutorials:digicdc
Differences
This shows you the differences between two versions of the page.
|
digispark:tutorials:digicdc [2015/01/08 00:40] digistump |
digispark:tutorials:digicdc [2016/06/09 12:03] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ===== DigiCDC - Digispark USB CDC Serial Library ===== | ||
| - | The DigiCDC library allows the Digispark or Digispark Pro to appear to a computer as a Virtual Serial Port when connected by USB. This makes it appear just like a standard Arduino and allows the use of the Serial Monitor built into the Arduino IDE. | ||
| - | |||
| - | The DigiCDC library is based on V-USB - because the Digispark does not have hardware USB support. This presents some unique limitations in how it works - outlined below: | ||
| - | |||
| - | - You must explicitly include the DigiCDC library - by placing the following at the top of your sketch <code>#include <DigiCDC.h></code> | ||
| - | - It uses a lot of RAM - half of the Digispark's RAM - so only include it when needed and watch your RAM usage. You can wrap strings in F() (ie. SerialUSB.print(F("test")) ) to put the string in flash memory instead of RAM | ||
| - | - You use it the same as Serial on an Arduino but with SerialUSB instead (ie. SerialUSB.read() instead of Serial.read() ) - The Pro also has Serial defined - but that refers to the hardware Serial port on Pins 6 and 7. | ||
| - | - The begin statement does not need a baudrate - it is a CDC device so it does not have a set baud rate - just use SerialUSB.begin() | ||
| - | - You must install the driver for windows - it is part of the driver package found in the Digispark Arduino release. | ||
| - | - It is slow - it transfers data very slowly - because it is a low speed USB device doing the job of a Standard speed device - and doing it all virtually without actual hardware support! | ||
| - | - Like all of our V-USB libraries you must use its delay function instead of delay() - so use SerialUSB.delay() when you need a delay in your code. | ||
| - | - SerialUSB.delay() or SerialUSB.refresh() must be called every 10ms or less in your code if no other SerialUSB call is made in that code. | ||
digispark/tutorials/digicdc.txt · Last modified: 2016/06/09 12:03 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
