Differences

This shows you the differences between two versions of the page.

--- buildone:basekit [2020/04/25 08:44]
digistump
+++ buildone:basekit [2020/04/25 09:25]
digistump
@@ Line 574: / Line 574: @@
 ==== Installing the Y Axis ====
+Take the previously assembled X axis, the remaining two metal axis rods, and the remaining 4 retaining rings.
+{{ :buildone:img_0463_large_-_copy.jpg?direct&300 |}}
+Feed one of the axis rods through the hole on the front of the printer - through the bearing on the X axis assembly (oriented so the hot end is facing the back of the printer) and through the matching hole on the back of the printer.
+{{ :buildone:img_0465_large_-_copy.jpg?direct&300 |}}
+Place the retaining rings on the axis on the front and back of the printer and tighten the set screws.
+{{ :buildone:img_0466_large_-_copy.jpg?direct&300 |}}
+Repeat for the other axis.
+{{ :buildone:img_0468_large_-_copy.jpg?direct&300 |}}
+{{ :buildone:img_0467_large_-_copy.jpg?direct&300 |}}
+{{ :buildone:img_0469_large_-_copy.jpg?direct&300 |}}

Digistump Wiki