======Soldering Headers to the Digispark======

=====Parts:=====

^ Part       ^ Quantity          ^Identification^
| Digispark|1| |
| 1x6pin female 0.1" pitch header| 1| |
| 1x3pin female 0.1" pitch header| 1| |

**Soldering:** If you are new to soldering we recommend the following tutorials:
Soldering Basics (http://www.sparkfun.com/tutorials/106) and Soldering Crash Course from the folks at Sparkfun (http://www.sparkfun.com/tutorials/354).
How to solder from the Curious Inventor: http://store.curiousinventor.com/guides/How_to_Solder

Adafruit has this excellent guide that starts with the tools needed and then shows detailed pictures, including some of the common problems that beginners experience (http://learn.adafruit.com/adafruit-guide-excellent-soldering)

**We assume for these assembly instructions that you know the basics of thru-hole soldering. If you don't check out the links above, these boards are very easy to solder - we promise!**


=====Assembly:=====


[[https://s3.amazonaws.com/digispark/images/m/digispark2.jpg|{{https://s3.amazonaws.com/digispark/images/t/digispark2.jpg}}]]

Solder each header into the Digispark, black plastic on top, solder from the bottom.

[[https://s3.amazonaws.com/digispark/images/m/digispark3.jpg|{{https://s3.amazonaws.com/digispark/images/t/digispark3.jpg}}]]

The Digispark Pro looks like this.

{{:digispark:tutorials:digisparkpro.png?direct&200|}}

If you'd like to use your Digispark with a breadboard you can cut 6 and 2 pin lengths of male headers (included for Kickstarters and Pre-orders) insert the 6 pin into the corresponding header and the 2 pin into the 5v and GND portion of the 3 pin female header. Flip the Digispark upside down and it should plug into most breadboards with the 5v and GND being connected into the power bus.