My Digispark 3D printed case :)

[BA.tech]

Hey all


I'm new here, just got my Digispark yesterday and i still don't know which project would best fit him...
I have some experience with the regular Arduino, i hope i will do fine with this little guy.


Any way, the first thing i did (after seeing how small and delicate it is) was the design the case
I'm using Shapeways to 3D print stuff so you can see it for your self (and order it also), it's hasn't been tested yet but i will get my first one and improve it as needed.
You can see it here: Digispark case.

If you have any suggestions, don't hesitate..

[JanWillem]

Digispark case, RGB case and bumpers can also be found on www.thingiverse.com/thing:41291
Printed on 3D printers like Ultimaker

[airship]

Digispark case, RGB case and bumpers can also be found on www.thingiverse.com/thing:41291
Printed on 3D printers like Ultimaker

I wish you could buy this one. I especially like the translucent RGB add-on case.

[DeuxVis]

Digispark case, RGB case and bumpers can also be found on www.thingiverse.com/thing:41291
Printed on 3D printers like Ultimaker

I wish you could buy this one. I especially like the translucent RGB add-on case.

I have a 3D printer (reprap).
I can print you one case for the cost of shipping if you like (plastic cost is nearly null for such little objects).

Contact me through a private message if you're interested.

[BA.tech]

good news, it arrived


i orderen it in blue plastic (nylon) and it fits a bit tight but fine.
the photos are a bit rotated, i tried to fix it but with no luck..



this where you can see it
http://shpws.me/nd3M