The Digispark > Digispark (Original) Support

device with unknown new version of Micronucleus detected.

(1/1)

Reep:
I have tried a multitude of ways to correct this, trying to find the 2.2 version of the micro nucleus, but I am stumped. Arduino is not sure how to upload the code onto the chip. I do not know what to do.

mp57:
Digispark USB PCB. I have the same problem. Firmware 2.2. Immediately after the USB connection, the power LED is lit (=OK), but the LED on the P1 is flashing about 10 sec. (pin 6 of TINY85).
Unfortunately, it also flashes after programming. Digispark cannot be used.
Does anyone know a solution? Thanks, Petr

Navigation

[0] Message Index

Go to full version