Digistump Forums

The Digispark => Digispark (Original) Support => Topic started by: Amu0373 on September 26, 2018, 01:12:56 am

Title: Soldering usb cable to Digispark
Post by: Amu0373 on September 26, 2018, 01:12:56 am

Hi, I want to solder an usb cable to the digispark. I couldn't find any example of it. But looking at schematics I think the following will work:

Solder the usb cable wires directy to the digispark:
Data+ of cable to D3
Data- of cable to D4

Could someone confirm or have a picture as an example?

Thanks, Alex.

Title: Re: Soldering usb cable to Digispark
Post by: granzeier on October 12, 2018, 12:39:24 pm

I figure that you already know, but in case you forgot: you will also need to connect the +V and -V (+5 and ground) lines - unless you are providing power elsewhere.