Digistump Forums
The Digispark => Digispark (Original) Support => Topic started by: pdc on January 28, 2013, 05:13:42 pm
-
Hi,
I received my 3 digisparks today, loaded the driver into winxp, and on one, the device was found and windows appeared happy. On the other 2, windows says a USB device malfunctioned. Looking into other posts, I do have 1 solid led on the left and a blinking one sort of in the middle of the device, so they seem somewhat alive. I can't remember where my hub is hiding, so in the meantime, any ideas?
Thanks,
Paul
-
Paul,
Can you look at the section in this post about the USB connector alignment and see if you think that might be the issue:
http://digistump.com/board/index.php/topic,248.0.html
Or put another way, does it seem like on the two that are having issues that the USB connection end is offset a bit to one side compared to the one that is working?
I'd also try a USB extension cable, different port, and/or hub - as the contacts might just be slightly off center.
It is possible they are defective but two seem unlikely given the current defect rate is about 0.02%
Let me know if any of that helps,
Thanks,
Erik
-
Erik,
I checked them against each other. Slight, slight difference in width. Went and bought a usb hub at staples, and now they are all recognized. Guessing that my usb port is pickey. So all is well and now I have a USB hub shaped like a dog with each leg a USB port:) Cheapest one they had.
Thanks,
Paul
-
Paul
Glad you got it to work, sorry you had to buy a hub but at least it was a cool one. I noticed the cheapest ones on ebay right now look like dead fish - I think a dog one is much better!
Thanks,
Erik