Digistump Forums

The Digispark => Digispark Projects => Topic started by: BA.tech on January 26, 2013, 03:41:40 pm

Title: My Digispark 3D printed case :)
Post by: BA.tech on January 26, 2013, 03:41:40 pm
Hey all


I'm new here, just got my Digispark yesterday and i still don't know which project would best fit him...
I have some experience with the regular Arduino, i hope i will do fine with this little guy.


Any way, the first thing i did (after seeing how small and delicate it is) was the design the case :)
I'm using Shapeways to 3D print stuff so you can see it for your self (and order it also), it's hasn't been tested yet but i will get my first one and improve it as needed.
You can see it here: Digispark case (http://shpws.me/nd3M).

If you have any suggestions, don't hesitate..
Title: Re: My Digispark 3D printed case :)
Post by: JanWillem on January 29, 2013, 06:24:16 am
Digispark case, RGB case and bumpers can also be found on www.thingiverse.com/thing:41291
Printed on 3D printers like Ultimaker

Title: Re: My Digispark 3D printed case :)
Post by: airship on February 01, 2013, 12:33:08 pm
Quote from: JanWillem on January 29, 2013, 06:24:16 am
Digispark case, RGB case and bumpers can also be found on www.thingiverse.com/thing:41291
Printed on 3D printers like Ultimaker

I wish you could buy this one. I especially like the translucent RGB add-on case.
Title: Re: My Digispark 3D printed case :)
Post by: DeuxVis on February 08, 2013, 08:15:25 am
Quote from: airship on February 01, 2013, 12:33:08 pm
Quote from: JanWillem on January 29, 2013, 06:24:16 am
Digispark case, RGB case and bumpers can also be found on www.thingiverse.com/thing:41291 (http://www.thingiverse.com/thing:41291)
Printed on 3D printers like Ultimaker

I wish you could buy this one. I especially like the translucent RGB add-on case.

I have a 3D printer (reprap).
I can print you one case for the cost of shipping if you like (plastic cost is nearly null for such little objects).

Contact me through a private message if you're interested.
Title: Re: My Digispark 3D printed case :)
Post by: BA.tech on February 17, 2013, 11:24:25 am
good news, it arrived :)


i orderen it in blue plastic (nylon) and it fits a bit tight but fine.
the photos are a bit rotated, i tried to fix it but with no luck.. :(



this where you can see it
http://shpws.me/nd3M (http://shpws.me/nd3M)




(http://images1.sw-cdn.net/model/picture/674x501_892069_821153_1361128836.jpg)
(http://images1.sw-cdn.net/model/picture/674x501_892069_821158_1361128860.jpg)
(http://images1.sw-cdn.net/model/picture/674x501_892069_821136_1361128378.jpg)
(http://images1.sw-cdn.net/model/picture/674x501_892069_821134_1361128348.jpg)