The Oak by Digistump > Oak Support

Detailed Pinouts and CAD files for OAK and ACORN

(1/5) > >>

defragster:
When available and stabilized having the pin function / location details published would be good.   Including Eagle CAD type part and layout drawings for OAK and ACORN and ideally the OAK 'base shield' for use in designing OAK compatible boards, and perhaps OAK 'Proto' or other shields for building off an OAK.

kroegerama:
I'm also waiting for the detailed layout drawings. Can't wait to start designing my own shields.

Seems, Erik does not read here at all, though :(

defragster:
I'd give him this much credit:Erik does read as it fits his schedule in making critical things work out as best he can.

His schedule these days it probably a bit overwhelming - even if all is going well - which I hope it is.

Since the ACORN is selling stand alone in 10's and 100's - the drawings should be out ASAP - not sure if he's making final layout changes for tuning?  OAK boards outputs are defined to fit the PRO/Original pinout - and until the ACORN pins are fixed his OAK adapter board mapping is changing ...

Solice:
I'd check again when the Beta boards start arriving.  Erik mentioned something during the kickstarter campaign about having them ready for us when they start shipping.

defragster:
@Solice- my expectation too - I wrote that on another thread yesterday in response to 'software' posting: http://digistump.com/board/index.php/topic,1791.0.html

Though the ACORN's are built into OAK's for Beta - they should be finalized by then.

Navigation

[0] Message Index

[#] Next page