Pro fails to respond [Fixed]

[cheetahkid]

I am not sure after I tried it on both computer's usb both win7, one intel i7 and the other amd64
on the amd64 doesn't work after the usb installation, looking on the usb viewer, it is in there. but only say com1 in the ide which would be the motherboard of amd64.
2nd part, after a few minutes the pro stopped blinking which arduino uno, mega and micro would carry on, is that normal?

on the intel, usb not recognized any on usb2 till I went on usb3, it didn't show "digitspark" but couple of weird symbols.

[cheetahkid]

I am sure it is working uploading into the Pro and not the COM (a bit confused by it because I use the arduino which does use the COM), correct me on this?

now the blinker LED not working at all, checking supply which is there 4.8-4.97V, on pin 0 or 1 there is no sign of active blinker, it stays low.

I tried disconnect and download on it own seem to respond waiting for a device, so that ok.
connected the device and will download I used the download "start" from example>digispark
I notice it did say Digispark 16.0MHz- NO USB (Tiny core) in the Tools>board, so I used that but there is no PRO on it. correct me on that one? yep, I was in the wrong core.

[cheetahkid]

Finally it is working.
I was in the wrong place and wrong core, I now used Arduino Nightly (1.5.6-r2 will not work!) and installed addon
I found one of Directory or folder, hardware should be Hardware with the capital H, easy mistake.
first time bootloading, my computer start to recognised my Pro and the blinker works. (turns out when bootloading the Digispark and not the Pro causes not to blink any more)