Hole pattern not compatible with arduino DUE... :(

[Largol]

I received my Digix last week and tonight, I wanted to plug a pedalSHIELD Arduino guitar pedal. And we did check with a colleague that this shield is compatible with an arduino DUE hole pattern but unfortunately not with the Digix hole pattern (PCB version 1).

However there's only one hole that does match and "drops" again the audio jack plug !

Regards.
Largol.

[digistump]

We tried to keep the original hole placement but it was impossible - otherwise the wifi module would have to be inside the board which would result in lots of noise and bad reception

[Largol]

Ok i understand I like good Wi-Fi strength
I think of a 3D printed special spacer ....

Regards.
Largol.